Usually, the location of septic filters is in the wastewater tank at the tee or in a separate chamber outside and near the wastewater tank. But how do we know when to clean the septic filter, and how do you avoid drainfield damaging?
Do you need a filter in a septic tank?
The accumulation of solids in the filter results in low performance of the septic tank but creates a problem that is much easier and less expensive to clean and maintain than the accumulation of solids in the drainage field. Septic tank installed because the residue (and sometimes the undissolved detergent clot) can significantly increase the blockage of the sewage system.
We often recommend a septic system filter to protect drainage fields with limited capacities or low absorption sites. If the septic tank is properly maintained, including frequent checks for the collection and disposal of solids, a filter may not be required.
Avoid damaging a drain box when cleaning the sewage filter
Temporarily stop the running water in the building, which is operated by the septic tank during the inspection and cleaning of the clarifier. Preventing wastewater from entering the tank during this interval prevents the wastewater from entering the discharge area during the removal of the cleaning filter.
Check the waste water level in the wastewater tank. When the wastewater tank opens to the access door to check and clean the septic tank filter, check the waste water level in the waste tank before removing the filter. If the level of wastewater in the tank (floating debris, sewage, sludge) is unusually high, this indicates a blockage of the system (possibly clogged filters).
Do not remove the filter if the tank is too high. Otherwise sewage, solid, floating foam, and grease will enter the drain box, which could clog the filter or degrade its life. If the tank is too high (sliding over the inlet or outlet door or the tank is full up), it is recommended to pump the tank before removing and cleaning the septic effluent filter.
tgwastewater 